This is an old revision of the document!
The following information is under construction and not completed
The following is a basic guide to using Global Cache products with iViewer & guiDesigner.
These instructions assume you already have a basic understanding of guiDesigner and iViewer. See our guiDesigner/iViewer Quick Start Guide if you are not familiar with our software yet.
The first thing you will need to do is connect your Global Cache device to your network so iViewer can connect to it to send it commands. To do this you will need to follow your hardware's documentation. This can be found at the Global Cache website http://www.globalcache.com
Next we need to add the Global Cache device as a system in guiDesigner. So add a new system and fill in the relevant properties as required.
How you enter commands into guiDesigner varies depending on the format. We will list some basic information below, please refer to the http://www.globalcache.comGlobal Cache website for more information.
IR commands send to Global Cache hardware must be in a specific format as shown below
sendir,<connectoraddress>,<ID>,<frequency>,<repeat>,<offset>,<on1>,<off1>,<on2>,<off2>,….,<onN>,<offN> |
---|
where;
<connectoraddress> is as defined in Global Cache documentation
<ID> is |0|1|2|…|65535| (1)
<frequency> is |15000|15001|….|500000| (in hertz)
<repeat> is |1|2|….|50| (2) (the IR command is sent <repeat> times)
<offset> is |1|3|5|….|383| (3) (used if <repeat> is greater than 1, see below)
<on1> is |1|2|…|65635| (4) (number of pulses)
<off1> is |1|2|…|65635| (4) (absence of pulse periods of the carrier frequency)
An example of an IR Command in Globacl Cache Format looks like this:
sendir,1:1,1,38109,1,1,171,171,21,64,21,64,21,64,21,21,21,21,21,21,21,21,21,21,21,64,21,64,21,64,21,21,21,21,21,21,21,21,21,21,21,21,21,64,21,64,21,21,21,21,21,21,21,21,21,21,21,64,21,21,21,21,21,64,21,64,21,64,21,64,21,64,21,3810 |
---|
To learn your IR code in Global Cache format, you will need to use their iLearn software (if you have a Global Cache IR Learner). Or use their iConvert software to convert hex (CCF) to Global Cache IR format.