This is an old revision of the document!
The CommandFusion SW16 is a 16 input switch interface, with 16 dimmable status LED outputs and 4 dimmable backlight LED outputs.
Using the inputs you can trigger rules, essentially using macros to control anything within the CFLink network.
The SW16 is designed to be used with any keypad, custom or off the shelf.
The information panel can be found on the top of the SW16.
The 40 pin header on the front of the unit has pins allocated for all the dry contact inputs and LED outputs, as well as one pair for defining the LED voltage level.
The SW16 ships with a ribbon cable ready for use.
Note: Short pin 37 or 38 to Ground to select the LED output voltage you wish to use. Only one of these should be shorted at any time. Leave the other floating.
The 5-pin CFLink connector is used to communicate with other CFLink devices on the network.
The MicroSD slot is used to expand the on-board memory via MicroSD cards.
The SW16 ships with the following accessories:
92cm (36 inch), 40-pin, rainbow-colored ribbon cable.
One end is a standard header connector, ready to plug into SW16.
Other end is stripped and tinned wires, ready for connecting to a button panel.