This shows you the differences between two versions of the page.
hardware:modular-base-units:din-mod4-configuration:general-tab [2014/03/04 04:00] aaron created |
hardware:modular-base-units:din-mod4-configuration:general-tab [2014/03/04 04:12] (current) aaron [1 - Device Info] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== General Tab ====== | ====== General Tab ====== | ||
{{:hardware:modular-base-units:din-mod4-configuration:general_tab.png?nolink|}} | {{:hardware:modular-base-units:din-mod4-configuration:general_tab.png?nolink|}} | ||
+ | |||
+ | The general tab allows you to configure the following information. | ||
+ | |||
+ | ===== 1 - Device Info ===== | ||
+ | Change the CFLink ID of the device by using the up and down arrows or by entering a number. The CFLink ID must be between 2 and 238. This number must also be unique on the CFLink network, if there is a CFLink conflict the device will [[software:system-commander:quick-start-guide:quick-start-page-2#automatic-id-conflict-resolution|automatically assign the device a different ID]]. | ||
+ | |||
+ | In this tab you can also view the devices serial number, firmware version and MAC address. | ||
+ | |||
+ | To turn off UDP broadcasting, un-tick the box labelled ''UDP 10207 Broadcast''. | ||
+ | |||
+ | ===== 2 - RS232 ===== | ||
+ | Change the settings for the in built RS232 port. | ||
+ | |||
+ | Under ''COM Mode'' , be sure to set the either Program (PGM) or 232 mode. Program mode will allow the device to be detected and programmed via RS232, 232 will allow the MOD4/DIN-MOD4 to control third party devices via the RS232 port. | ||
+ | |||
+ | If you are having problems connecting to the device in Program mode, be sure that the ''Baud Rate'' is set to 115200. | ||
+ | |||
+ | All other settings are set as per a standard RS232 connection and should be changed if required to communicate to your desired device. | ||
+ | |||
+ | ===== 3 - Buttons ===== | ||
+ | The ''Reset'' button will reset the device, it is essentially the same as removing the power for a short amount of time. | ||
+ | |||
+ | The ''Refresh'' button will request the settings from the device and display them in System Commander. You will lose any unsaved settings when you click this button. | ||
+ | |||
+ | The ''Save'' Button will save any settings you have entered in System Commander to the device. | ||
+ |