This shows you the differences between two versions of the page.
hardware:modules:mod-hry2 [2012/09/07 04:05] jarrod |
hardware:modules:mod-hry2 [2012/09/07 04:34] (current) jarrod |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== MOD-HRY2 ====== | ====== MOD-HRY2 ====== | ||
- | The MOD-HRY2 is a modular unit with 2 x 250VAC 15A Relay ports.\\ | + | The MOD-HRY2 is a modular unit with 2 x 250VAC 15A Latching Relay ports.\\ |
- | This module can be used to switch high amperage loads directly. | + | This module can be used to switch high amperage loads directly.\\ |
+ | Latching relays will remain in their open or closed state on power loss, allowing loads to return to their previous states without interruption. | ||
+ | |||
+ | <WRAP important round 50%> | ||
+ | === Max Load per Relay Channel === | ||
+ | 250VAC, 15A | ||
+ | </WRAP> | ||
===== Ports ===== | ===== Ports ===== | ||
Line 12: | Line 18: | ||
- Port 2 - | - Port 2 - | ||
- | ==== Rear Connector ==== | + | ===== Rear Connector ===== |
The rear of every module contains a module port, used to connect the module into the modular controller base unit (DIN-MOD4, etc). The pinout for this port is not published. | The rear of every module contains a module port, used to connect the module into the modular controller base unit (DIN-MOD4, etc). The pinout for this port is not published. | ||