This shows you the differences between two versions of the page.
hardware:modules:mod-hry2 [2012/08/10 01:25] aaron created |
hardware:modules:mod-hry2 [2012/09/07 04:34] (current) jarrod |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== MOD-HRY2 ====== | ====== MOD-HRY2 ====== | ||
+ | The MOD-HRY2 is a modular unit with 2 x 250VAC 15A Latching Relay ports.\\ | ||
+ | This module can be used to switch high amperage loads directly.\\ | ||
+ | Latching relays will remain in their open or closed state on power loss, allowing loads to return to their previous states without interruption. | ||
+ | |||
+ | <WRAP important round 50%> | ||
+ | === Max Load per Relay Channel === | ||
+ | 250VAC, 15A | ||
+ | </WRAP> | ||
+ | |||
+ | ===== Ports ===== | ||
+ | Front of the module has four captive screw terminals, allowing for large gauge wiring. | ||
+ | |||
+ | **Pinout** | ||
+ | - Port 1 + | ||
+ | - Port 1 - | ||
+ | - Port 2 + | ||
+ | - Port 2 - | ||
+ | |||
+ | ===== Rear Connector ===== | ||
+ | The rear of every module contains a module port, used to connect the module into the modular controller base unit (DIN-MOD4, etc). The pinout for this port is not published. | ||
+ | |||
+ | |||