CommandFusion Wiki

Documentation Resources

User Tools

Site Tools


hardware:cflink:lanbridge-cflink-protocol

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

hardware:cflink:lanbridge-cflink-protocol [2021/05/17 00:00]
jarrod
hardware:cflink:lanbridge-cflink-protocol [2021/05/17 00:00] (current)
jarrod
Line 18: Line 18:
 By default, authentication on LAN Bridge is disabled. To enable it, use the [[#​pwd-login-password|Configure Password command]]. By default, authentication on LAN Bridge is disabled. To enable it, use the [[#​pwd-login-password|Configure Password command]].
  
-When authentication is enabled, the LAN Bridge will send a `RLANATHcommand when first connecting. When this command has been sent, no other commands will be accepted until the correct username and password has been received.+When authentication is enabled, the LAN Bridge will send a ''​RLANATH'' ​command when first connecting. When this command has been sent, no other commands will be accepted until the correct username and password has been received.
  
-If an incorrect login message is received, the LAN Bridge will respond with [[hardware:​cflink:​error-codes#​lan-bridge-solo-error-codes|`RLANERRmessage, with error code 134]].+If an incorrect login message is received, the LAN Bridge will respond with [[hardware:​cflink:​error-codes#​lan-bridge-solo-error-codes|''​RLANERR'' ​message, with error code 134]].
  
-Once successfully logged in, the LAN Bridge will reply with `RLANWHOresponse to acknowledge that login is correct and the device will now respond to other commands.+Once successfully logged in, the LAN Bridge will reply with ''​RLANWHO'' ​response to acknowledge that login is correct and the device will now respond to other commands.
  
 ===== Queries ===== ===== Queries =====
hardware/cflink/lanbridge-cflink-protocol.1621209605.txt.gz ยท Last modified: 2021/05/17 00:00 by jarrod